mobile/line:Â Â 008613776999969
plate  rolling machine
Main Function
This machine is a  three-roller bending machine and used to do pre-bending the end of plate, rolling it into round, cone and other shapes.
Delivery date: 30days.
Technical description of W11S-30X3000
MODEL
W11S-30X3000
Maximum width of bending plate
3000 mm
Maximum thickness of bending plate Â
16mm(Q235)
Diameter of upper roller
450mm
Diameter of bottom roller
255mm
Center distance between two bottom rollers
400mm
Min inside diameter when full loading
About 750mm
Plate bending speed
4m/min
Power of main motor
30kw
Voltage and frequency
              380V 50HZ
Main Part and Techniques
No.
Main Machine part
Technical Requirement
1
Top Roller Device
Material
45 steel
Techniques
forging piece go through rough machining then quenching and tempering treatment at HB260~300
finish turning then medium frequency quenching of surface at  HRC47~52
2
Bottom Roller Device
Material
45steel
Techniques
forging piece go through rough machining then quenching and tempering treatment at HB260~300
finish turning then medium frequency quenching of surface at HRC47~52
Chrome surface for good looking and good rust resistant. The chrome is three layer, that's NI-Ni-Cr. The chromoe finish is more bright than polish which offer good looking. The chrome surface also longer lifetime thn stainless or galvanized raincap. It is used on tractors and bardening vehicle. Just contact us if you are interested in. For proper installation, the exhaust cap needs clearance for counterweight rotation and should be installed at a point that allows for this without interference. The exhaust cap should be placed on the outer diameter of the stack pipe. Allow approximately ¼" of clearance between cap and top of stack. for Further information, just feel free to contact us
Chromed Rain Cap
Chromed Rain Cap,Muffler Rain Cap,Tractor Exhaust Rain Cap,Rain Cap For Exhaust Pipe
Hebei Lantian Automobile Noise Silencer Producing Co., Ltd. ,