Let's take a look at RFMicron, a company that has made some truly impressive passive RFID sensors. They continue to improve the technology and apply it to certain types of sensors they support as well as specific applications. One of the more exciting and promising is the tire pressure detector. Cars and light trucks are required to be equipped with tire pressure detection systems (TMPS) in the United States, Europe, and many other parts of the world. This obviously increases the cost per vehicle ($20-$500).
RFMicron can replace these sensors and electronic devices with a cheaper passive RFID system. And this seems to be obvious to automakers - a more powerful system and a significantly lower cost. Once you have an UHF RFID reader in the car, for a variety of purposes, you can also have passive RFID sensors and tags throughout the car, at very low cost. More than 80 million new cars are manufactured and sold each year. If RFMicron can fully understand this market, it will quickly turn them from one small company to one of the largest RFID hardware manufacturers. And this is just one of the areas of application they are pursuing. This is a company worthy of optimism!
Plastic Injection Clear Housing
The transparency of the plastic injection transparent shell matrix resin itself has a great influence on the transparency of PP plastic products. In order to improve PP transparency, a small amount of polyacrylate resin with good transparency and compatibility can be added.
(1) the inorganic nucleating agent mainly consists of ultra-fine talc powder and SiO2, and also includes calcium carbonate, mica powder, inorganic pigments and fillers, etc., which is cheap in price and rich in source, but has certain influence on the gloss and transparency of the products.
(2) organic nucleating agent organic nucleating agent is a kind of organics with low relative molecular weight, represented by sorbitol and its derivatives. It has good compatibility with matrix resin and can significantly improve product transparency and surface gloss.
(3) in the case of sorbitol, when the amount of nucleating agent exceeds 0.3%, the effect of transparency improvement is not obvious, and even decreases. However, when the dosage is less than 0.2%, the nucleation quantity is insufficient and the transparency is not increased enough. It can be seen that the amount of nucleating agent should be between 0.2-0.3%. Therefore, suitable nucleating agent content can better improve the transparency of PP.
Plastic Injection Clear Housing,Injection Molded Transparent Shell,Injection Molded Transparent Shell Proofing,Transparent Plastic Housing,Clear Plastic Housing
Timeplex Industrial Limited , https://www.timeplexhks.com