Explosion-proof flashlights are used for fire protection in fire, electricity, industrial and mining enterprises and other inflammable and explosive places.
â–³ Do not incinerate or disassemble the battery. The chemicals in it are corrosive and can damage the skin and eyes.
â–³ Do not pull the lead or plug of the battery to prevent damage to the solder joints and joints.
â–³ Different types of batteries cannot be mixed.
â–³ Soldering on different types of batteries requires soldering with a connecting piece or the like.
â–³ Fully charge with a small current before initial use.
â–³ Do not charge in parallel, otherwise irregular charging current will be generated.
â–³ Do not reverse the battery or short-circuit it.
â–³ After the battery is fully discharged, the charging time should be extended to reach the saturated battery.
△ Store the battery in a cool, ventilated, dry environment at a temperature not higher than 45 °C.
â–³ Do not store a large number of batteries in a densely charged or half full battery.
â–³ Do not touch acid gas and avoid getting close to fire.
cheap plastic injection molds and mould manufacturer 1-Start from part design analysis 2-Mold design drawing and DFM report available so you can see how is the mold going to be before mold making 3-If product is complex,moldflow report will be present as well 4-In house mold making shop ensure you mold quality under well control. 5-Normally it takes 20-40 days to make mold,precise time depends on part design
Ppr Pipe Fitting Mould,Pipe Fitting Mould Making,Polypropylene Random Pipe Fitting Mould,Ppr Fitting Mould
Taizhou Zijing Plastic and Mould Co.,Ltd. , https://www.zijingmould.com